MM2: Wire management – Part 2

In the last post I was worried about the wiring around the controller getting messy again, as the wires for all the end-stops still had to be added… But as you can see, I did it without really messing anything up!

2013-11-16 15.03.33 (Large)

Here the wire for the Y-min end-stop is ready, and just outside the left side of the picture the wire for X-min is going into the vertical cable carrier.

2013-11-16 15.02.39 (Large)

The wires for Z-min follow the power wires going into the controller a bit, and going all the way to the back of the printer, then a bit towards the front again to not have to have some extra wires just going across to make them shorter.

2013-11-16 15.02.56 (Large)

Leave a Reply