Automated cat food dispenser PCB’s are in!

Today the PCB’s for my automated cat food dispenser arrived from dirtypcbs, and once again they look gorgeous. Even the ID for the boards got placed under the power supply, so when assembled it it completely hidden.

This is also the first time I am trying to put my logo on a board, and it looks pretty good too. Before sending it off I was worried about the little version on the front, but it turned out decent too. The “since 2011” underneath is very difficult to read, and might not even be possible for others to figure out without knowing, but the whole logo gets the job done anyways.

2016-05-18 17.08.30 2016-05-18 17.09.05

Next up is some soldering, and some programming. And maybe next version should have a button for resetting the settings in the ESP8266 too.

Leave a Reply